[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Bumpers etc.
> Cut-up these indestructible belts and wrap them around the pulley
> instead of using heat-shrink. The seam where the cut is made could
> destroy the small red rubber belts. Perhaps, though, the belt could
> be wrapped with its teeth facing out and then a matching belt could be
> used as the drive belt. This would require two (per motor) low-friction
> rods or some-such to hold the belt into place and to wrap it snugly-enough
> around the pulley to work, but it might just work. There are
> variations on the idea possible, too.
I see bad things happening if this method isn't done well in terms of
craftsmanship. Belts would start flying all over the place...ahhh!!!!
stressed out,
Cindy